Firtree Build, Enfield: Extension Ideas 2026

The best extension ideas for a 1960s or 1970s house all start with the same two questions: what is the garage doing, and what is the roof made of? The garage is often the cheapest space you own, and the roof is usually the biggest structural decision. Get those two right and the rest is detail.
This guide comes from the Firtree Build team in Enfield. It covers flat-roof garages, trussed roofs, rear and side extensions, and the surveys to do before you draw anything. Planning figures are from the Planning Portal, as at November 2026. If your house is older, see our guides to 1920s house extension ideas and 1930s semi extension ideas.
What a 1960s or 70s house is made of
Houses from these decades are built differently from the 1930s semi, and the differences decide what you can do. The roof is usually trussed rafters: factory-made timber triangles, often with a W-shaped web, covering the full width of the house, so there are no purlins and no open loft. Pitches are shallower, often much lower than a 1930s roof, which affects headroom and the volume sums. Many have an attached or integral garage with a flat or very low roof, often built far lighter than the house. The ground floor is often a concrete slab with cavity walls above, rather than the suspended timber floor of the interwar house. And estate layouts bring open fronts, shared drives and planning conditions attached to the original permission.
None of that is bad news. A cavity wall on a slab is easier to extend from than a solid brick wall on a timber floor. The trussed roof is the part that needs respect.
Check these before you draw anything
Each of these can change a design after the money has been spent. Start with planning conditions. Some estates were built with a condition removing permitted development rights, or requiring the garage to stay as a parking space. Ask the council for the planning history of your address and read the decision notice, because a garage conversion that looks like permitted development may not be.
Next, asbestos. It was widely used in building products in these decades, and on these houses the places to check are textured ceiling coatings, garage roof sheets, soffits and flue pipes. A refurbishment survey before work starts is the safe way, and it is cheaper than stopping a site. Finally, the garage structure itself. Dig a trial pit and look at the foundation depth. A garage that only ever carried a flat roof may have shallow footings and thin walls, and that decides whether you can build on top. It is better to find out in the survey than on day three.
The garage
The garage is where many 1960s and 70s projects start, and there are four things you can do with it.
| Idea | What you get | What decides it |
|---|---|---|
| Convert inside the shell | A utility, office, playroom or extra bedroom with no change to the outside | Floor level, damp proofing, insulation, and any planning condition on parking |
| Convert and extend at the rear | The garage joins up with a rear extension to form one large room | Foundations of the old garage, and how the two roofs meet |
| Add a bedroom over the garage | A first-floor room and often a new bathroom | Foundations and wall strength, and the planning rules on side extensions |
| Knock down and rebuild | New foundations and walls, a clean start | More cost, but you stop inheriting the old garage’s problems |
For the inside conversion, Building Regulations nearly always apply, covering insulation, ventilation, damp proofing, fire and any structural change. The planning side depends on your estate’s conditions, so check first.
Common problems and how to fix themThe garage floor is often a step or two lower than the house, with no damp-proof membrane. The fix is a new insulated floor build-up that brings it level with the house, so there is no awkward step. The old up-and-over door opening needs a proper cavity wall with matching brick, not a thin panel. And the lintel over the door needs checking, because it may have been sized for the garage door and nothing else.
A bedroom over the garage
This is a very common request for a two-storey side extension, and an easy one to get wrong. The garage walls and footings were designed for a flat roof, not a floor and a pitched roof above, so underpinning or new foundations alongside may be needed. On planning, permitted development covers single-storey side extensions only. A two-storey side extension needs a planning application, and councils often want the first floor set back from the front and in from the boundary so the street does not read as a terrace. Ask Enfield what it expects for your road.
Then there is the front. A new brick bedroom next to a tile-hung 1970s front needs thought, and the front elevation section below covers it. A new wall on or near the boundary also raises a party wall question, which our article on party wall agreements in Enfield explains. If the foundation check is bad, the sound answer is usually to rebuild the garage walls properly. It costs more than reusing them, and it costs less than fixing cracks later.
Rear extensions
A single-storey rear extension is the easiest win. Under permitted development a semi or terrace can go up to 3 m, or up to 6 m with prior approval, though conservation areas and removed rights change that. These houses help in two ways: the concrete ground floor makes the new floor level easy to match, and a trussed roof bears on the outer walls only, so internal walls at roof level carry little roof load.
The low eaves on these houses leave little height for a pitched roof, so a flat roof with a roof lantern often works well, as long as it is a proper warm roof with falls and a decent edge. A pitched roof tied into the main roof looks like part of the house but gives little room for a high-ceilinged kitchen. If you want an open-plan room with steel across the rear wall, check which walls carry the first-floor joists before anything is cut. Which outer walls carry the roof depends on which way the trusses run, and internal walls at first-floor level may still support floors. A survey will tell you which is which, so do not guess.
The trussed roof
This is where these houses part company with a 1930s semi. A trussed roof is a set of factory-made timber triangles, typically about 600 mm apart, with diagonal webs running across the loft. The webs are structural. If you cut one to make room, the roof can move or fail. And if a previous owner has already cut one, for a water tank or a ladder say, that is a repair job before it is a conversion job.
To convert, the loads of the trusses are taken by new steel beams or a new structure, and then the webs can come out. The usual route is steel beams in the existing roof, spanning wall to wall and carrying the roof with the trusses cut out beneath. It suits most conversions, but it needs an engineer’s design and the roof is open while the work is done. The alternative is new attic trusses, replacement trusses designed with a room in the roof and craned in. That suits a regular roof shape, but the roof has to be stripped and crane access matters. Raising the roof is the last resort for a low roof with no other option, and it needs a planning application because the roof goes above the existing one.
The engineer’s calculations come first, then the steel order, then the scaffold. If a builder offers to start without calcs, walk away.
Why the volume sums bite harder on a low roof
Permitted development lets you add 50 cubic metres of roof space to a semi (40 for a terrace), including earlier additions. The shallower the original pitch, the more volume a dormer of the same height adds. Our sums assume a dormer 5.2 m wide with a 2.3 m high rear face, and ignore the 20 cm setback from the eaves. On that basis a dormer adds about 33 cubic metres on a 22.5 degree roof, which is about two thirds of the allowance, about 30 on a 25 degree roof (around 60 percent), and about 24 on a 30 degree roof (about half). Your designer must measure the real house.
That is why a low trussed roof can use up the allowance with a modest dormer, where a steep 1930s roof does not. See the same sums for a steeper roof in our 1930s semi loft guide. If you want more room than the allowance, the usual route is a planning application, and our guide to planning permission for a loft conversion in Enfield sets out what that involves. A shallow roof also gives less headroom, so check the internal height with our guide to whether a loft is suitable for conversion before you fall for a design.
Services and drains
On these houses the garage often holds the gas and electric meters, the consumer unit, the boiler, the stopcock and sometimes the soil stack. A garage conversion is also a service relocation, so plan it early. Moving the boiler means a new flue, and flue terminals have clearance rules to openings and boundaries. Moving meters and the consumer unit needs the supplier and a competent electrician, and may take weeks to book. Look at where the soil and surface drains run before you pour a new floor. Ask for the services to be included in the quote at the start, because they are the first place a budget leaks.
In Enfield the water company is Thames Water. If a public sewer or lateral drain runs close to or under the building, you may need a build-over agreement with Thames Water before you extend. Drains on estates often run along the back of houses and under garages, so ask Thames Water about your address before the design is fixed.
The front elevation
1960s and 70s fronts often have tile hanging, wide low windows, timber fascias and mixed brick. A new side extension in a different brick looks bolted on. There are two ways round it. You can match the existing materials so the extension looks like part of the house, though old brick and tile are hard to match exactly. Or you can re-clad the whole front so old and new look designed together. That costs more but is a real kerb appeal gain, and planning may need to see it.
Whichever you pick, align the new windows with the old ones. A row of windows at different heights is what makes an extension read as an afterthought.


How to choose
If you are standing in the garden with a pencil, start with the garage. If it is in good shape and you need a room, convert it, after checking the planning conditions. If you need a bedroom and a bathroom, add over the garage if the foundations allow, or build a rear extension and a dormer. With a low roof and a big wish list, do the volume sums before you design anything. And if you want it all, phase it, and design the first phase so the second does not undo it.
We would sooner spend an hour at the house before a quote than send a price that turns into a variation.
FAQs
Can I convert a garage without planning permission?
Often yes, since the work is internal, but check the original planning permission for a condition removing permitted development or requiring the garage to stay as parking. Building Regulations almost always apply.
Can you convert a loft with trussed rafters?
Yes. The trusses cannot simply be cut. The roof loads are taken on new steel beams or a new structure designed by an engineer, and then the webs can come out.
Can I build a bedroom over my garage?
Often, but the garage walls and foundations were built for a flat roof, so they must be checked. A two-storey side extension needs planning permission, and councils often want the first floor set back and in from the boundary.
Do 1960s and 70s houses contain asbestos?
They can. Asbestos was widely used in building products in these decades, so have a refurbishment survey before work begins.
How big a rear extension can I build under permitted development?
On a semi or terrace, up to 3 metres, or up to 6 metres with prior approval, outside conservation areas and subject to the other conditions.
Why does my low roof use up the permitted development volume?
The flatter the original roof, the more volume a dormer of a given height adds, so a modest dormer can use a large share of the 50 cubic metre allowance.
Talk to a Local Builder About Your 1960s or 70s House
We start with the garage and the roof, then the planning position, and tell you honestly what is possible.
Firtree Build is based in Enfield. See our house extension builders in Enfield page, or get in touch to arrange a visit. Our cost calculator gives a first guide figure.
